NB8B PWR 42MM RADIATOR INSTALLATION

kiezon · Postby **kiezon** » Wed Feb 20, 2019 11:48 am

Hi all,

I'd just like to know what individuals who have fitted the NB PWR 42mm radiator into their cars were required to do in order to install this item.

I'm aware I may be required to bend A/C lines or condenser brackets. Unsure how to go about doing this without damaging anything. I prefer to install this radiator with as little irreversible modification as possible. I.e. drilling, cutting etc.

Was there anything else required to do?

Cheers,
Kieron

Sent from my SM-G950F using Tapatalk

StanTheMan · Postby **StanTheMan** » Wed Feb 20, 2019 12:14 pm

they are very soft aluminum. The condenser pipes I'm talking about......be daring. just move them a little bit

I have a 1.8 in a NA6 chassis. yes our pipes are a little differently placed. perhaps. be gentle about it. you'll be fine I bent mine out of place. one didnt screw up properly underneath because there just isn't any room.

Luke · Postby **Luke** » Wed Feb 20, 2019 2:57 pm

I too was worried about having to bend pipes when I put a CSF 42mm radiator in my SE.
Guess what?
I didn't have to bend a thing. It just went straight in.