Problem with AiM SoloDL2
Moderators: timk, Stu, zombie, Andrew, -alex, miata
-
bruce
- Speed Racer
- Posts: 7662
- Joined: Fri Apr 25, 2003 11:00 am
- Vehicle: NA8 - Turbo
- Location: Victoria
- Contact:
Re: Problem with AiM SoloDL2
Yay! I'm running an old Autronic from 2003 (I think an SM-2). I look at the ancient serial cable...
-
greenMachine
- Forum Guru
- Posts: 3945
- Joined: Thu Apr 24, 2003 11:00 am
- Vehicle: NB SE
- Location: Sports car paradise - Canberra
- Contact:
Re: Problem with AiM SoloDL2
Resurrecting this old thread.
I am contemplating upgrading my ECU, probably a Haltech Elite 1500. maybe even a dash too ...
In that event, the Autronic, WB and likely the Solo will go onto the block, so I rang Ron about what implications his fix for my problem will have on my sales campaign. He advised that 'absolutely none, it will work as advertised on any ECU*'. Hmm I seem to have heard that before, somewhere ...
I will take him at his word, and draw the conclusion the solution to my problem was a firmware kludge fix to the handshaking protocols, subsumed by subsequent 'official' FW updates as mentioned above.
* May not be a literal quote, but he was adamant it would work fine.
I am contemplating upgrading my ECU, probably a Haltech Elite 1500. maybe even a dash too ...
In that event, the Autronic, WB and likely the Solo will go onto the block, so I rang Ron about what implications his fix for my problem will have on my sales campaign. He advised that 'absolutely none, it will work as advertised on any ECU*'. Hmm I seem to have heard that before, somewhere ...
I will take him at his word, and draw the conclusion the solution to my problem was a firmware kludge fix to the handshaking protocols, subsumed by subsequent 'official' FW updates as mentioned above.
* May not be a literal quote, but he was adamant it would work fine.
I never met a horsepower I didn't like (thanks bwob)
Build thread
NB SE - gone to the dark side (and loving it
)
Build thread
NB SE - gone to the dark side (and loving it
)Who is online
Users browsing this forum: No registered users and 3 guests
