Driver side front sitting low

Wheels, Suspension, Brakes & Tyres questions and answers

Moderators: timk, Stu, zombie, Andrew, -alex, miata

Sirois
Driver
Posts: 40
Joined: Mon May 09, 2016 10:01 pm
Vehicle: Non MX-5

Driver side front sitting low

Postby Sirois » Thu Feb 01, 2024 11:35 pm

Hi everyone,

I have an NB2, the front driver side is sitting visibly low, by about 15-20mm.

Everything looks OK though. Spring is in one piece etc.
Any ideas what that might be, or what I should be checking?

User avatar
greenMachine
Forum Guru
Posts: 3942
Joined: Thu Apr 24, 2003 11:00 am
Vehicle: NB SE
Location: Sports car paradise - Canberra
Contact:

Re: Driver side front sitting low

Postby greenMachine » Fri Feb 02, 2024 8:50 am

Done anything lately to the suspension? Stock suspension I am assuming? Wheel/tyre checks out ok? Look at the LR and see if there is anything there jacking that corner up, and the RF down. Hit any big potholes hard recently?

No broken/missing bolts in the suspension arms (including lower shock mount and the LBJ bolt in there), the bushes look ok and the arms themselves not bent? The spring is the next (only?) candidate left on the list. Measure as closely as you can the height (length) of the spring on both sides, maybe it has sagged for some reason. If the springs are the same, the problem is in the suspension itself, recheck all bolts/bushes and the arms etc.

It could be the wheel bearings, but for that degree of drop they would have to have been ground down to dust, and the noise and wobbly steering/vibration would have alerted you ages ago.

Good luck, let us know how you go

:mrgreen:
I never met a horsepower I didn't like (thanks bwob)

Build thread

NB SE - gone to the dark side (and loving it 8) )

93_Clubman
Speed Racer
Posts: 11684
Joined: Mon Aug 08, 2005 11:35 pm
Vehicle: Clubman
Location: Melbourne

Re: Driver side front sitting low

Postby 93_Clubman » Sat Feb 03, 2024 10:49 am


StillIC
Racing Driver
Posts: 854
Joined: Sat Jan 01, 2011 2:30 pm
Vehicle: NA6
Location: Newcastle

Re: Driver side front sitting low

Postby StillIC » Sat Feb 03, 2024 4:13 pm

Sirois wrote:Hi everyone,

I have an NB2, the front driver side is sitting visibly low, by about 15-20mm.

Everything looks OK though. Spring is in one piece etc.
Any ideas what that might be, or what I should be checking?

Does it look low in every place you park it, or just one or some places? Most pavement is very wobbly and far from both flat and horizontal. Be careful that this is not the issue. I have spent a lot of time in my life just finding 4 tyre spots on pavement that are horizontal and in the same plane to the nearest mm which normally requires building up one wheel spot at least.

If the car is low in one corner, it must be 'high' (proportionally higher) in the diagonally opposite corner. Check that this is the case before heading to the low corner to look for the problem.

Else, check the spring (broken, possibly sagged but unlikely) and that the damper still has its nitrogen pressurised (if it is that type). Other issues are unlikely to cause such a drop unless significant in nature and they should therefore be obvious as a result.

PS: Check your tyre pressures are all equal too. This gives a reasonable datum from which to measure.
WP:1.12.492 SMPN:1.16.403 SMPS:1.05.473 SMPGP:1.53.256 SMPB:2.22.181

StillIC
Racing Driver
Posts: 854
Joined: Sat Jan 01, 2011 2:30 pm
Vehicle: NA6
Location: Newcastle

Re: Driver side front sitting low

Postby StillIC » Sat Feb 03, 2024 4:24 pm

Sirois wrote:...Spring is in one piece etc...

On this point specifically, I broke a spring on the strut of a Datsun Stanza many years ago. It happened as I pulled into the driveway of a shopping centre (Charlestown Square for you Novocastrians reading). I heard the clunk and the car pulled immediately to one side, then stayed that way on the way home.

I was pretty sure I had broken a spring, but for the life of me could not see the break at the shopping centre. Once I got the car home and pulled the wheel off, I still couldn't see the break! I suspected it was broken in the bottom turn and a half which had a plastic tube around the spring wire. Once I had the strut apart, I was proven correct. Corrosion had occurred from water sitting inside the plastic tube, eating through the spring wire surface, starting a crack which then fatigued and broke.
WP:1.12.492 SMPN:1.16.403 SMPS:1.05.473 SMPGP:1.53.256 SMPB:2.22.181

User avatar
bruce
Speed Racer
Posts: 7661
Joined: Fri Apr 25, 2003 11:00 am
Vehicle: NA8 - Turbo
Location: Victoria
Contact:

Re: Driver side front sitting low

Postby bruce » Sun Feb 04, 2024 1:23 pm

Flat tyre....
My money is on a strut which has given up the ghost.

User avatar
greenMachine
Forum Guru
Posts: 3942
Joined: Thu Apr 24, 2003 11:00 am
Vehicle: NB SE
Location: Sports car paradise - Canberra
Contact:

Re: Driver side front sitting low

Postby greenMachine » Sun Feb 04, 2024 10:30 pm

Good luck finding a strut, Bruce, unless you are talking about the one holding the bonnet open .... :wink: 8)

Hopefully the OP will be back soon with an update.

:mrgreen:
I never met a horsepower I didn't like (thanks bwob)

Build thread

NB SE - gone to the dark side (and loving it 8) )

User avatar
bruce
Speed Racer
Posts: 7661
Joined: Fri Apr 25, 2003 11:00 am
Vehicle: NA8 - Turbo
Location: Victoria
Contact:

Re: Driver side front sitting low

Postby bruce » Mon Feb 05, 2024 12:22 pm

I've been talking in US/European terms about shock absorbers a lot recently. I just started using the term strut.

Sirois
Driver
Posts: 40
Joined: Mon May 09, 2016 10:01 pm
Vehicle: Non MX-5

Re: Driver side front sitting low

Postby Sirois » Mon Feb 05, 2024 4:20 pm

Are shocks hard to find for these cars?

I haven't had a chance to look under there just yet.
But there isn't any odd noise, or even odd handling.

The car isn't too stable at high speed over bumps, but I assume that is more to do with worn suspension rather than any one specific issue.

In any car I will have a look and if I do find something wrong, I will post back

93_Clubman
Speed Racer
Posts: 11684
Joined: Mon Aug 08, 2005 11:35 pm
Vehicle: Clubman
Location: Melbourne

Re: Driver side front sitting low

Postby 93_Clubman » Tue Feb 06, 2024 8:24 am

Sirois wrote:Are shocks hard to find for these cars?

Not particularly, but it can be an expensive exercise.

User avatar
greenMachine
Forum Guru
Posts: 3942
Joined: Thu Apr 24, 2003 11:00 am
Vehicle: NB SE
Location: Sports car paradise - Canberra
Contact:

Re: Driver side front sitting low

Postby greenMachine » Tue Feb 06, 2024 8:48 am

What do want to replace the shocks with?

Stock - should be a lot of second hand ones, but dubious age/condition (these are 20+ yo cars)? I don't know what the availability is from Mazda, but I assume aftermarket sellers have options.

Coil-overs - this is a real can of worms, everyone has an opinion. What is your priority - price or performance, and if performance, road, road and track, or track?

:mrgreen:
I never met a horsepower I didn't like (thanks bwob)

Build thread

NB SE - gone to the dark side (and loving it 8) )


Return to “MX5 Wheels, Suspension, Brakes & Tyres”

Who is online

Users browsing this forum: No registered users and 6 guests