ManiacLachy wrote: Boomslang's communications
Remember there are a few major holidays over in the US at the moment so responses may not be 'fast'.
Haltech Elite 750 PNP
Moderators: timk, Stu, zombie, Andrew, -alex, miata
-
Magpie
- Speed Racer
- Posts: 7468
- Joined: Fri Feb 11, 2011 12:49 pm
- Vehicle: NA6
- Location: Purga, QLD
Re: Haltech Elite 750 PNP
Remember there are a few major holidays over in the US at the moment so responses may not be 'fast'.
-
takai
- Fast Driver
- Posts: 181
- Joined: Fri Mar 02, 2018 10:29 am
- Vehicle: NA6
Re: Haltech Elite 750 PNP
The 3 plug adapters do exist, but were made for the E8/E11 not the Elite 750. No problem though as they are easily repinned on the AMP Tyco plug.
I picked up this one before just going to a full custom loom:
Sold it to someone on the FB group, so if you ask there it might still be going unused.
Failing that, Bartune (on here) was making an adapter board for the MS3 to the 3 plug (and 2 plug) setup. It would be relatively trivial to switch the DB25/35 connectors to a wire through solder setup and just make a short pigtail to the E750 plug.
I picked up this one before just going to a full custom loom:
Sold it to someone on the FB group, so if you ask there it might still be going unused.
Failing that, Bartune (on here) was making an adapter board for the MS3 to the 3 plug (and 2 plug) setup. It would be relatively trivial to switch the DB25/35 connectors to a wire through solder setup and just make a short pigtail to the E750 plug.
Return to “MX5 Audio, Electronics & Lighting”
Who is online
Users browsing this forum: No registered users and 3 guests
