Never had an engine warning light come on with any of my mx’s. This morning it did and I think I’ve solved the issue - the little pipe on boost solenoid had fallen off. Would never have found it without looking on here!
Now to cancel the warning. Is there a simple trick to do that or do I need to go to a workshop?
Se engine warning light
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
trader
- Racing Driver
- Posts: 797
- Joined: Fri Oct 10, 2003 10:41 am
- Vehicle: NB SE
- Location: canberra
Se engine warning light
NB SE, NA 1.8.
-
Roadrunner
- coyotes after you
- Posts: 1108
- Joined: Tue Nov 06, 2012 9:02 pm
- Vehicle: NB SE
- Location: Newcastle
Re: Se engine warning light
Usually disconnecting the battery for a while does it. Otherwise a cheap OBD reader will be able to read and clear it.
MeepMeep
-
greenMachine
- Forum Guru
- Posts: 3945
- Joined: Thu Apr 24, 2003 11:00 am
- Vehicle: NB SE
- Location: Sports car paradise - Canberra
- Contact:
Re: Se engine warning light
I'd suggest unplugging the ecu, except that those suggestions are much easier! Especially since the nuts securing the kick plate protecting the ecu are non-tamper and difficult to remove if nobody has previously accessed the ecu.
I never met a horsepower I didn't like (thanks bwob)
Build thread
NB SE - gone to the dark side (and loving it
)
Build thread
NB SE - gone to the dark side (and loving it
)-
trader
- Racing Driver
- Posts: 797
- Joined: Fri Oct 10, 2003 10:41 am
- Vehicle: NB SE
- Location: canberra
Re: Se engine warning light
Thanks guys - disconnected the battery for 20 mins and it worked! Luckily I knew my radio code!
NB SE, NA 1.8.
Who is online
Users browsing this forum: No registered users and 6 guests
