Fitting a Variable Intermittent Wiper Stalk

Technical Guides primarily to do with the NC series

Moderators: timk, Stu, zombie, Andrew, -alex, miata

User avatar
TieNN89
Speed Racer
Posts: 2012
Joined: Mon Nov 26, 2007 8:27 pm
Vehicle: NC
Location: Brisbane
Contact:

Fitting a Variable Intermittent Wiper Stalk

Postby TieNN89 » Sun Jan 22, 2012 12:50 am

No idea why but Mazda decided to cheapen out with the NC and not fit a variable intermittent wiper stalk but thankfully they fitted it in the RX-8 and the one in the RX-8 slides into the NC with no issues.

I don't think I really need to explain what this does, but in short its a speed adjustment as to how long before the wipers next wipe the windscreen in intermittent mode.

For those looking for one there are a Left and a Right wiper stalk. Make sure you get the correct one because as far as I'm aware the left wiper stalk was only fitted to RX-8s that went to Japan and Australia, every other country had the wiper stalk on the right side.

Here is a pic of both wipers stalks

Image


What is required?
RX-8 Wiper Stalk
Phillips Head Screwdriver
Some Masking Tape


Step 1: Remove the 3 screws circled in red

Image


Step 2: Loosen the steering height adjustment allowing the steering wheel to freely move up and down

Step 3: Split the cover in half (top and bottom)

Step 4: Remove the two screws circled in red and unplug the wire circled in blue

This should loosen the wiper stalk and you should be able to slide it out

I highly recommend putting a few layers of masking tape as pictured because it is a very tight squeeze to get the wiper stalk out and won't be any easier putting the new one in
You could probably undo a few more things (not sure what) and it would probably make it a lot easier to remove and fit but I didn't have much issue doing it this way so never looked at another way of doing it.

Image


Step 5 Slide the new wiper stalk in and repeat the steps above in reverse


End Result

Image

kris
Fast Driver
Posts: 310
Joined: Tue Jul 13, 2010 10:26 pm
Vehicle: NC
Location: Northern Sydney

Re: Fitting a Variable Intermittent Wiper Stalk

Postby kris » Sun Jan 22, 2012 8:06 am

Thankyou this is quality ! Where did you source the correct wiper stick from ?

User avatar
TieNN89
Speed Racer
Posts: 2012
Joined: Mon Nov 26, 2007 8:27 pm
Vehicle: NC
Location: Brisbane
Contact:

Fitting a Variable Intermittent Wiper Stalk

Postby TieNN89 » Sun Jan 22, 2012 1:21 pm

I sourced mine from the UK off a wreaked import RX-8


Return to “NC [2006 +]”

Who is online

Users browsing this forum: No registered users and 6 guests